Hotun Hiflo Dry Trap Tundish - Black HHB100C

The Hotun hiflo dry trap tundish can be used for large unvented hot water heaters (more than 15 litres capacity) and boilers (with a Hotun shield). By connecting a hotun hiflo dry trap tundish it allows a safe and visible discharge from the boiler temperature/pressure relief valve to be connected to a waste/soil without allowing any foul odours back into the building, thereby allowing a compliant connection.

Worcester Bosch, Vaillant, Ideal Heating, Ariston and KD Navien all allow the use of hotun hiflo with shield to safely discharge the boilers PRV and, when applicable, to combine the condense into the same single pipe discharge below the hotun for a compliant connection.

Product Features

• 126mm tall x 57mm wide
  
• 0.5” flat face tap connection on inlet
  
• 32mm HDPE or universal/compression compatible outlet
  
• Allows trickle and full bore discharges up to 18 litres/min
  
• Temperature rated up to 100 degrees celcius
  
• Air break to drain
  
• Safe and visible means of discharge
  
• 10 year warranty
  
•  Available in black or white
  

Please Note: Fittings to connect both the inlet and outlet to the pipework do not come with this product.

The product is supplied with a flat faced rubber inlet washer which must be used and only hand tightened, under no circumstances should a fibre washer be used.